Beper BT.710Y Manual De Instrucciones página 9

EN
Crepe maker Use instructions
6. After about 3 minutes the product is ready to be used.
7. Grip the product by the handle and turn it upside down so that the non-stick plate comes into contact with the
mixture previously prepared and placed in the bowl.
PAY ATTENTION NOT TO IMMERSE ALL THE PRODUCT.
8. Return the product to the initial position, and if necessary wait a few seconds for the crepe to reach a good
browning.
9. With the help of a wooden or plastic spatula (not metal because it could damage the surface) lift the edges of
the crepe, turn it and wait the cooking ends before removing it.
10. After use, switch off the product with the On / Off button, unplug the power cord from the power outlet, allow
the product to cool and proceed with cleaning.
CLEANING AND MAINTANANCE
IMPORTANT:
DISCONNECT THE POWER CORD FROM THE POWER OUTLET AND LEAVE THE PRODUCT COOL
DOWN BEFORE CLEANING.
NEVER IMMERSE THE PRODUCT IN WATER OR OTHER LIQUID.
NEVER STORE THE PRODUCT WHILE IT IS STILL HOT AND / OR DIRTY.
NEVER WRAP THE CABLE AROUND THE PRODUCT TOO STRICTLY TO AVOID DAMAGING IT.
CLEAN THE PRODUCT AFTER EACH USE.
1. The product can be cleaned using a soft, slightly damp cloth.
2. Clean the bowl with water and neutral soap, rinse well and dry.
3. Do not use too aggressive soaps, abrasive sponges or other products that could damage the product.
4. Wait until the product is dry before storing it or using it again.
Technical data:
Power:800W
Power supply: 230 V~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9