Parameters For Spin Cycles - Primer LP-08 Manual De Instrucciones

•
•
•
(Yes/No).
•
starts running. The pause will be indicated on the screen and an acoustic signal is emitted (Yes/No).
•
If this parameter is active, before starting the cycle, the machine will go to pause status, and the
message "Pause programmed" is displayed on the screen. To continue running the programme,
press the PLAY button.
3.1.2

Parameters for spin cycles:

•
•
Medium (3), Maximum (4).
The Medium (3) and Maximum (4) values are only available in high- and medium-speed machines
respectively.
Range can be configured.
•
Untangling: Untangle at the end of the spin cycle (Yes/No).
•
Optimum distribution: If this option is active, the machine does not drain in the previous cycle.
•
Pause programme: This allows you to pause the programme before the cycle in question starts
running. The pause will be indicated on the screen and an acoustic signal is emitted. (Yes/No).
12
Move while filling: Rotate drum while machine is filling (Yes/No).
Movement while draining: Rotate drum while machine is draining (Yes/No).
Thermal stop: Indicate the moment from which the time stipulated for the cycle is counted
Pause programme: This allows you to pause the programme before the cycle in question
Time: Value, in minutes, of the spin length. Range can be configured from 1 to 99.
Speed: Spin speed. There are 4 different speeds to select from: Minimum (1), Normal (2),