Master FACTORY FACT 20 Manual De Instrucciones página 11

pleasant comfort and the absolute silence is assured without moving
parts. Without air movements there isn't the spreading of particles
or dust.
Switch on the heater simply by connecting to the power supply.
•
Do not touch the metallic parts when the heater is working.
•
Ensure that the rays of the heater are directed towards the area it
•
is wished to heat. If necessary, change the angle of inclination by
loosening the screws of the support or the modules.
In unoccupied premises it is recommended that the heating sys-
•
tem is switched off by disconnecting from the electrical supply.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distanc-
es less than 2.70 m.
All users should be made aware of all aspects of operation
and safety and these instructions should be retained for ref-
erence.
5. MAINTENANCE
The IR Industrial Heaters contain no moving parts and therefore very
little maintenance is required other than to ensure that there is no
excessive build-up of dust/dirt on the reflectors or emitters as this
can cause overheating and premature emitter failure. To clean the
appliance, wipe off with a damp cloth. Wait until it is completely dry
before connecting to the power supply.
6. EMITTER REPLACEMENT
The emitters used in the IR heater are robust and if knocks and shock
vibrations are avoided, they will last for around 3000 hours. They
should be substituted even before if there are signs of aging. Due to
the special sealing and anti-shock design of the heater, the emitters
are not intended to be user replaceable. Please ensure that all emit-
ters are replaced via the service network.
11