Restore Default Values: Reset - Fermax SKYLINE DUOX Manual De Instalador

DUO DUO X X X X X A A A A A udio Sk DUO udio Sk udio Sk
DUO DUO udio Sk udio Sk yline
DUO DUO DUO X X X X X A A A A A udio Sk udio Sk udio Sk
udio Sk yline
DUO DUO udio Sk
EN

RESTORE DEFAULT VALUES: RESET

The DUOX amplifier has a 'Reset' function which can be used to
restore programmed default parameters.
RESET Mapping (call button code)
1.- Reset amplifier: remove power.
2.- Press the SW1 button, connect power supply and keep SW1
button pressed until you hear the reset confirmation sound:
beep-beep (5 seconds).
Lock Release Times
See DUOX Advanced Programming Manual cod. 97699.
RESET Programming Code from keypad panels
You can reset the programming access code (if the previous one
is forgotten), to the default code.
1.- Disconnect the panel's power supply.
2.- Short-circuit between the system´s "Bs" and "-". If the system is
equipped with an exit button, just press and hold it down.
3.- Reconnect the panel's power supply and do not remove the
short circuit
From the panel with a keypad you can Reset the parameters to the
factory default values.
Manual, cod. 97701 at www.fermax.com.
yline yline
yline yline
yline yline
yline
yline
.
Download the Direct Panels Programming
Pag 33