Restore Default Values Reset; Reset Mapping (Call Button Code); Programming Lock Release Times - Fermax CITYLINE DUOX Serie Manual De Instalador

DUO DUO X CITYLINE KIT 3-24L X CITYLINE KIT 3-24L
DUO DUOX CITYLINE KIT 3-24L DUO X CITYLINE KIT 3-24L X CITYLINE KIT 3-24L
DUO DUO DUOX CITYLINE KIT 3-24L X CITYLINE KIT 3-24L X CITYLINE KIT 3-24L X CITYLINE KIT 3-24L
DUO DUO X CITYLINE KIT 3-24L
M)
JP1
Camera LEDS
JP2 :
Line termination integrated into the amplifier for possible use.
IMPORTANT NOTE:
Camera focus
To adjust the camera's image, see ANNEX: Voice assisted configuration in button panels.
Instructions included with this equipment.
You can also set it by temporarily connecting a keypad (ref. 7439), or via the duox
programmer (ref. 3254) locally connected.
Download the manuals at: www.fermax.com.
- Direct Video Duox Panels Programming Manual, cod. 97900.
- DUOX Programmer Manual ref 3254, cod. 97731.
DUOX Amplifier Call:
•
Panels with an address "0" in each block allow for communication with telephones
when picked-up or with the monitors doing an auto-start with it and when the
communication lines are free. If you do not want this feature do not assign this
address to any panels. The monitors also have the option of an auto-start with
panel 1 in your block and panel 0 of the General Entrance.
•
The call is made to the home by pressing the corresponding button.
RESTORE DEFAULT VALUES: Reset
The DUOX amplifier has a 'Reset' function which can be used to restore programmed
default parameters.

RESET Mapping (call button code)

1.- Reset amplifier: remove power.
2.- With the SW1 button pressed, power and maintain the SW1 button for 5 seconds. The
LED will blink quickly to indicate that button mapping has been restored.

Programming Lock Release Times

There are two programmable lock-release activation times:
- Lock-release time set from the residence.
- Lock-release time set from the exit button (connected to the 'BS' and '-' terminals).
Notes:
• Values:
- Lock-release time:
- Exit button time:
Page 10
LEDS ON
lit when the camera is activated
01..99 sec. (Default: 03).
00..99 sec. (Default: 06). Deactivated: 00.
LEDS OFF
Always Off