Aluminium Compound Milling Cutter; Operation; Initial Operation; Switching On And Off - Mafell MF 26 cc Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
Fasten
the
reversible
countersunk screws and retighten these with the
torx screw driver (4 Nm).
The two parts have been inserted correctly if the rear
of a knife edge is resting against the carrier body and
the countersunk screw can be screwed in that far that
the surface of the countersunk screw is located below
or on the same level as the surface of the reversible
knife (see Fig. 10). The radial blade protrusion of
max. 1.1 mm (3/64 in.) is thus guaranteed.

4.12 Aluminium compound milling cutter

Aluminium compound milling plates
cannot be turned as they are
soldered in. (A blunt tool must be
reground).
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular
attention
instructions".

5.2 Switching on and off

Switching on: First unlock the switch-on lock
by pressing the locking lever 7 (Fig. 5). Then,
keeping the locking lever depressed, activate
the gearshift lever 8.
As this is a switch without locking device, the
machine will only run for as long as this gearshift
lever is pressed.
The built-in electronic system provides for jerk-free
acceleration when the machine is switched on and
under load readjusts the speed to the fixed setting.
In addition, this electronic system reduces the motor
output in case of an overload, i.e. the tool stops.
Switch the machine off then. Then switch the
machine on again and continue sawing at a reduced
feed speed.
The setting wheel 9 (Fig. 3) can be used to adjust the
tool speed in a continuously variable manner between
3600 and 6250 rpm.
knives
with
to
the
chapter
"Safety
the
Level
1
2
3
4
5
6
Material groups
- PVC, plexiglass, PA, aluminium compound
Level: 1 - 6
-
- Hardwood, softwood, plywood
Level: 3 - 6
-
- Coated panel materials
Level: 4 - 6
-
- Plaster
Level: 3 - 5
-
Switching off: To switch off, release the
gearshift lever 8. The built-in automatic brake
limits the slowing time of the tool to approx. 5 s.
The switch-on lock is automatically reactivated
and secures the groove-cutting machine against
accidental switch-on.

5.3 Incising the guide rail (special accessories)

Danger
Initial start-up
Trim the splinter guard 38 (Fig. 4)
with the saw blade prior to initial
start-up:
Place the rail onto a level support.
Put down the machine at the start of the rail with
the groove 24 (Fig. 6) in the base plate on the
spring of the rail.
Set the cutting depth to approx. 3 mm (1/8 in).
Switch on the machine and slide it evenly in
cutting direction across the entire length. The
newly formed cut edge on the splinter guard
serves as tracing edge for the saw blade, the
adjustable groove cutter and the slitting unit.
Place the rail onto the workpiece.
Push it against the workpiece and align it with
the marking. In order to fix the rail, clamp the rail
-28-
Speed rpm
3600
4130
4660
5190
5720
6250
Tabla de contenido
loading

Tabla de contenido