Battery Installation - Yukon 26342 Manual De Instrucciones

COMPONENTS AND CONTROL ELEMENTS
1. Built-in laser IR Illuminator
2. Battery compartment knob
3. LED indicator
4. Riflescope and built-in IR Illuminator ON/OFF button
5. Eyepiece adjustment ring
6. Controller
7. Video output
8. Weaver rail
9. Objective lens cap
10. Lens focus knob
9
1 2
7 6
3
3
4
5
8 10

BATTERY INSTALLATION

џ Turn the knob (2) of the battery compartment cover 90°
counterclockwise.
џ Remove the cover by raising it by its lug.
џ Slide in two АА batteries so that the "+" and "-" match the
polarity on the inner side of the cover; rechargeable AA
batteries may be used.
џ Close the cover of the battery compartment cover and
turn the knob (2) of the cover 90° clockwise.
џ Battery charge level is shown on the display (icon
In case of complete battery discharge, empty battery
icon turns red. Colour of the LED indicator changes
from green to red.
Note: to ensure long and reliable operation it is recommended that you use quality rechargeable batteries with a
capacity of at least 2500 mAh. Please do not use batteries of different types or batteries with various charge levels.
MOUNTING THE RIFLESCOPE ON WEAPON
џ To ensure precise shooting the sight should be correctly mounted on a rifle. Please follow these steps.
џ Install the mounting rings (bought separately) on the riflescope's tube and tighten the screws with the help of a hex-
nut wrench. If the eye relief is not sufficient, you can use mount Yukon SW-30 (#29048).
џ Install the riflescope on the rail of your rifle and make sure it is securely fixed.
џ The riflescope should be mounted as low as possible without touching either the barrel or the receiver.
џ Before tightening the mount rings make sure you have the necessary eye relief that allows you to see a full field of
view.
Pic.1
WARNING: if the riflescope does not have sufficient eye relief, its rearward motion may injure the shooter when the
rifle
- +
-
+
).
Pic.2
4