Assembly Instructions - Texas Hobby 300 Manual De Instrucciones

The tiller should only be operated by fit and healthy individuals. If you get tired,
take frequent breaks. Never use the machine after drinking alcohol.
The factory-fitted control units, such as the gear cable from the handle, must not
be removed or covered.
Always check that nuts and bolts are tight before starting the machine.
Using the machine on steep slopes is dangerous!

Assembly instructions

1. Figure 1 shows the contents of the kit:
a. Blades.
b. Depth skid with transport wheels.
c. Tiller with cables.
d. Upper handlebar
e. User manual and mounting bolts.
f. Lower handlebars, right and left.
2. Fit the two lower handles using the accompanying bolt. Make sure that the handles
are turned the right way.
Fit handle (a.) on the right and handle (b.) on the left.
Figure 2, 3.
3. Fit the upper handle using the accompanying bolt set.
Figure 4, 5.
4. Mount the throttle cable (a.) and clutch cable (b.) as shown in the figure.
Figure 4
5. Apply grease to the transmission, as described in this manual.
Figure 6.
6. Mount blades, depth skid and transport wheels using the accompanying cotter
bolts and pins
Figure 7, 8.
Maintenance
Add grease until it runs out of the filler hole when the machine is horizontal.
- Remove the spark plug cover on the engine.
Add grease to the gear.
-
Place the pack of grease in a bucket of warm water. This will make the consistency
thinner, so it is easier to add to the gear. Avoid cutting off too much of the tip on the
pack. It is important that the tip is as pointed as possible.
Add grease until it comes out of the filler hole when the machine is horizontal.
Be careful of rotating blades
Only use the machine in areas where it can be
operated safely
8