Service & Maintenance - Ferm FDAG-750 Manual De Instrucciones

• The machine must always work opposite to the
direction of rotation. Therefore, never move the
machine in the other direction! Otherwise, the
danger exists of it being pushed uncontrolled
out of the cut (Fig. 7).
• Inspect the grinding disc regularly. Worn discs
have a negative effect on efficiency of the
machine. Replace the grinding disc on time.
• Do not put the machine down when the motor
is still running. Do not place the machine on a
dusty surface. Dust particles may enter the
mechanism.
• Always switch off the machine first before
removing the plug from the wall socket.
Never use the spindle lock to stop the
motor.
5. SERVICE & MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
after each use. Keep the ventilation slots free from
dust and dirt. If the dirt does not come off use a
soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Trouble shooting
Below we have listed a few probable causes and
solutions to which you can refer if your circular
saw does not function properly.
1. Machine fails to operate.
• Power turned off.
• (Extension) cable damaged.
Ferm
2. The elektromotor hardly reaches maximum
speed.
• The extension cable is too thin and/or too long.
• The mains voltage is lower than 230 V.
3. Machine overheats.
• Air vents are blocked. Clean them with a dry
cloth.
• The machine has been overloaded. Use the
machine for the purpose it is made for.
4. Excessive sparking or elektromotor runs
irregular.
• There's dirt inside the motor or the carbon
brushes are worn.
• Replace the carbon brushes or bring the
machine to a specialized repair centre.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. Separately you will find an
exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Warranty
For the conditions of warranty, please refer to the
separately provided warranty card.
GB
7