Door Alignment; Reversing The Door Position: Qhe02Ggm - Haier QHE02GGM Manual Del Usuario

INSTALLATION INSTRUCTIONS

DOOR ALIGNMENT

1. Unscrew the top hinge cover
screw and remove cover.
2. Loosen the top hinge screws
using a 10 mm socket
screwdriver.
3. Adjust the door or put a spacer between the hinge and
case, then tighten the screws.
4. Replace the top hinge cover and hinge cover screws.
REVERSING THE DOOR POSITION:
QHE02GGM
WARNING
Follow all steps when reversing the door
swing. Failure to follow these instructions, leaving off parts,
or overtightening screws, can lead to the door falling off and
result in injury and property damage.
• Ensure the appliance is unplugged and empty.
• Adjust the two leveling feet to their highest position.
• We recommend you have someone assist you.
TOOLS REQUIRED
• 10 mm socket screw driver
• Phillips style screw driver
PARTS INCLUDED
1. Upper Hinge Bracket
2. Leveling Leg
3. Machine Screw
4. Bottom Hinge Bracket
NOTE: To take the door off, it is necessary to tilt the
appliance backward. You should rest the appliance on
something solid, e.g. a chair, just below the top panel.
DO NOT lay the appliance completely flat as this may damage
the coolant system.
1. Unscrew the top hinge cover screw and remove cover.
Unscrew the upper hinge bracket screws and remove
hinge. Take off the left side screw covers. Pull the
appliance door upward to remove.
8
2. Remove left leveling leg and bottom hinge bracket by
unscrewing the mounting screws.
3. Install the leveling leg and bottom hinge bracket on the
opposite side. Tighten the bottom hinge bracket screws.
4. Slide the door onto the bottom hinge pin. Replace the
upper hinge bracket on the opposite side and check to
make sure the door/hinge is moving smoothly. Tighten the
screws of the upper hinge bracket. Replace the hinge cover
and right side screw covers. Tighten the hinge cover screw.
5. Check that the door is aligned, horizontally and vertically,
and that the seals are closed on all sides before finally
tightening the upper hinge screws and hinge cover screw.
Readjust the leveling feet.
49-60800-3