Easy Maintenance & Cleaning - Jay Fusion Cushion Manual De Instrucciones

E N G L I S H E N G L I S H
EASY MAINTENANCE & CLEANING
Monthly cleaning and regular maintenance may help extend the life
of your cushion. During cleaning, component inspection is recom-
mended.
Check the cover for tears and excessive wear and replace if ripped,
torn, or otherwise not fully functional. Inspect the fluid pad for
punctures or any other abnormalities.
Check the foam base to ensure foam consistency. While checking
the fluid pad if you ever feel the fluid is firmer in one area, simply
knead the fluid back to its original consistency and/or call your local
authorized supplier.
To clean cover
1. Remove the cover from the foam base and turn inside out.
2. Machine wash in warm water and drip or tumble dry on low
heat.
No ironing required.
CAUTION– DO NOT DRY CLEAN COVERS OR USE INDUSTRIAL WASHERS
AND DRYERS TO CLEAN COVER. DO NOT STEAM AUTOCLAVE.
DO NOT BLEACH.
To refit cover after washing, reinstall the cover on the foam base.
Ensure the back of the cover matches up to the back of the foam
base.
NOTE: If utilized in an institutional setting, write the resident's name with
a permanent marker on the content label of the covers. This will
help to ensure the return of the covers after washing.
Use only JAY-designed covers on JAY cushions. The cover is an
important part of allowing the immersion into the fluid insert which
redistributes the pressure. Changing the cover will alter this design
and its efficacy.
To clean foam base
Remove the cover, fluid pad, and inner cover from the foam base.
Wipe lightly with a damp cloth. Do not use soap. Do not submerge
in water. Wipe off with a clean cloth. Let it completely air-dry
before reassembly.
NOTE: Avoid submersion of the foam base in water.
Reinstall the cover over foam base. Ensure the back of the cover
matches up to the back of the foam base.
To clean fluid pad
Remove the cover from the foam base. Remove fluid pad from the
inner cover and wipe with warm water and soap. Rinse with a
clean, damp cloth. Then wipe dry with a clean cloth.
CAUTION– NEVER SUBMERGE THE FLUID PAD IN ANY LIQUID.
CAUTIO N– AVOID HARSH CLEANING OR ROUGH HANDLING AS THIS
MAY LEAD TO A DEGRADATION OF THE FLUID INSERT.
If at any time, the outer cover, inner cover, Foam base, fluid insert
or any other component appears to be wearing or you notice a
degradation in the texture, contact your supplier/Sunrise for evalua-
tion and further instructions.
To clean the ROHO ® DRY FLOATATION
Reference the ROHO ® DRY FLOATATION
Supplement for proper cleaning instructions.
121985 Rev. B
® Pad (if applicable),
® Pad Owner's Manual
4
M INTEN NCE
Laundry Care Symbols
REASSEMBLING THE JAY FUSION
CUSHION AFTER CLEANING
Follow cleaning and maintenance instructions as described in "Easy
maintenance and cleaning" then reassemble as follows.
WARNING
Place the JAY Fluid or ROHO® DRY FLOATATION®
Pad on the inner cover making sure that all Velcro®
strip locations are aligned. A misalignment or creation
of an edge could cause an unwanted pressure point
which could lead to injury.
Insert the foam base / inner cover assembly into the outer cover.
Ensure that the zipper is at the rear of the foam base where the
pelvic loading area is located.
Fluid insert
ND CLE NING
Machine wash in warm water
(60° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
Do not dry clean
ROHO ® DRY
FLOATATION ® PAD
Foam base