Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Risk of sudden starts. Can cause electrical shock
and personal injury. If power to pump is on when thermal
overload resets, pump may start without warning. If you are
working on pump, you may get an electrical shock or
A. Pump fails to operate
B. Pump fails to empty sump
C. Pump will not shut off
Cord Lift Warning
Risk of electrical shock.
Can burn or kill.
Do not lift pump by
power cord.
For parts or assistance, call Flotec Customer Service at
1. Check to be sure that power cord is securely plugged into outlet. Disconnect power to
outlet before handling pump or motor.
2. Check to be sure you have electrical power.
3. Check that liquid fluid level is high enough to activate switch or controller.
4. Check to be sure that 3/16" (4.7 mm) vent hole in discharge pipe is not plugged.
5. Check for blockage in pump inlet, impeller, check valve or discharge pipe.
6. Thermal overload may have tripped. Test start pump; if it starts and then stops immedi-
ately, disconnect from power source for 30 minutes to allow motor to cool, then recon-
nect to power source. Check for cause of overheating/overloading.
1. Be sure all valves in discharge pipe are fully open.
2. Clean out discharge pipe and check valve.
3. Check for blockage in pump inlet or impeller.
4. Pump not sized properly. A higher capacity pump may be required.
1. Check switch or controller automatic floats for proper operation and location. See instal-
lation instructions for switch/controller.
2. If pump is completely inoperative or continues to malfunction, consult your local ser-
viceman.
impeller may catch fingers or tools. Disconnect power before
servicing pump.
1. Attempting to lift or support pump
by power cord can damage cord and
cord connections.
2. Cord may pull apart, exposing bare
wires with possibility of fire or electri-
cal shock.
3. Lifting or supporting pump by power
cord will void warranty.
4. Use lifting ring or handle on top of
pump for all lifting/lowering of pump.
Disconnect power to pump before
doing any work on pump or attempt-
ing to remove pump from sump.
1476 0195
800-365-6832
4
Tabla de contenido
