Lenco LBT-120BK Manual De Usuario página 8

- Press REC button again to stop recording. -> LED is flashing for a short time, then LED light is
on again.
Note: Do not remove the USB storage device if the LED is flashing.
Mains connection
Ensure that the mains voltage of your home corresponds to the operating voltage of the unit.
Your unit is ready to be connected to a correct voltage of your location.
Amplifier connection
Connect RCA line out cable (10) to the AUX input on your amplifier:
- Red plug into R channel input.
- White plug into L channel input.
- Place the record of your choice on the turntable. If it is a 45 rpm, do not forget to place the
adaptor (1) on the record spindle.
- Choose the desired playing speed:
33 rpm -> button unlocked
45 rpm-> button locked.
- Release the pick-up arm clip.
- Place the cartridge vertically over the first track of the record, the turntable starts turning.
- When the record is over, the pick-up arm returns to its rest, the turntable stops turning
Take care that the pick-up lift stick is in down position, close pick-up arm lock to secure pick-up
arm.
Technical specification
Power Supply: AC100-240 60/50HZ
Power Consumption: 12W
Wow & Flutter: 0.3%
Distortion: 3%~4%
S/N: 50 dB
Audio Output Voltage: 500mV ±200mV
USB: 5V/500 mA
* IMPORTANT RECOMMENDATIONS
We advise you to clean your records using an impregnated rag with an antistatic product for
maximum enjoyment of your records and also to make them last.
We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 hours).
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from the
back to the front of the cartridge).
8