Hardware Installation; Software Installation - Topcom 2000 Manual De Usuario

1

Hardware installation

Attach the Camera Stand
The IP Camera comes with a camera stand. It has a swivel ball screw head that can be
attached to the camera's screw hole on the top/bottom panel. Attach the camera stand to the
camera and station it for your application.
Back panel
Ethernet connection: Connect an Ethernet cable to the network cable connector at the
camera's rear panel, then connect it to your network ( for example : your broadband cable/
DSL router)
The Antenna connector (for the wireless model IP CAM 2000): Screw the antenna on the
ANT connection and positionize it vertically.
Power connection: Connect the power supply to the 5V DC connection. Then plug in the
power adapter in the mains power outlet.
Reset button: If the reset button is pressed for more then 10 seconds, the camera will load
all default settings.
2

Software installation

Make sure that the IP CAM is connected by an Ethernet cable to your network.
The wireless model should also be connected by a network cable at this
point.
Insert the CD rom into your computer.
Wireless IP Cam 2000 / Wired IP Cam 1000
Wireless IP Cam 2000 / Wired IP Cam 1000
3