Tabla de contenido
7.0 Thicknessing
The following must be operated before thicknessing.
7.1 Turn the Model-Exchanging Switch on thicknesser
model.
7.2 Turn the handle anti-clockwise and take out the chip
ejector to release the safety switch for planer.
7.3 Turn the lock lever to unlock and take off the out-feed table. Then turn the lock lever (right) to hold the safety
switch for table.
7.4 Turn up the chip ejector hood and release the safety switch for thickness.
Then the motor can run normally. If there is mistake operation, the motor can't run and protect the operator.
7.5 Thicknessing without dust collector:
Take off out-feed table, slide guard extrusion clear of
table and set guard to highest position. Swing chip
ejection hood over the cutterblock and secure in
place with the lock levers as well as lowering the
guard onto it.
7
EN
Capítulos
Tabla de contenido
