Sound Adjustments; Performing The Basic Sound Settings - JVC KD-SH9750 Manual De Instrucciones

SOUND ADJUSTMENTS

Performing the basic sound
settings
You can set the speaker output balance,
subwoofer output level, and input level of each
source.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press SEL (select) repeatedly to
show one of the basic sound setting
(SEL) screens.
Each time you press the button,
SEL
the adjustable items change as
follows:
DSP
Canceled
• For DSP mode settings, see pages 25
to 27.
• For iEQ (sound mode) settings, see pages
28 and 29.
Indication
Fad Adjust the front
and rear speaker
balance.
Bal Adjust the left
and right speaker
balance.
Sub Out Adjust the
subwoofer output
level and cutoff
frequency level.
Vol Adj Adjust and store
the input level
of each source.
30
Fad/Bal
iEQ
Basic sound settings
Vol Adj
Sub Out
To do: Range
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
00 (min.)
|
08 (max.)
Low/Mid/High
–05 (min.)
|
+05 (max.)
2
Adjust the level.
To adjust fader and balance—Fad, Bal:
Make these two adjustments at the same
time.
• If you are using a two-speaker system, set
the fader level to "00."
To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.
To increase the level.
ATT
To decrease the level.
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press ¢
or
"Mid," or "High."
Low: Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid: Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz are
cut off to the subwoofer.
• Press 5 (up) or ∞
(down) to adjust the
fader.
• Press ¢
or
4 to adjust the
balance.
4 to select "Low,"