Positioning; Installation - Tecno-gaz B-MAX 4700S3 Manual Del Usuario

TECHINICAL SPECIFICATION
HAND PIECE DIMENSIONS
STAND DIMENSIONS
HAND PIECE WEIGHT
STAND WEIGHT
OPERATING VOLTAGE
BATTERY
LIGHT SOURCE
WAVE FREQUENCY
MAXIMUM POWER

POSITIONING

The components of B‐MAX are placed in a cellophane bag and then arranged in a
corrugated cardboard box with internal packing.
The device must be transported observing the rules for fragile goods.
There are no particular problems with storage; up to five boxes can be stacked and
there is no expiry date for the goods.
The original packaging should be kept for the entire guarantee period, since it is only
with this packaging that damage during transport can be avoided.
Failure to comply with the above instructions will terminate the guarantee.
The packaging components should be disposed of in compliance with the current
standards in the country where the instrument is used.

INSTALLATION

Before installing the device, check that it is intact; notify the dealer if there are signs of
transport damage. WARNING! Do not switch on the device.
B MAX must be placed on a stable surface, away from instruments that generate
strong emissions of heat and electromagnetic radiation that can damage the installed
electronics.
It must be connected to a 230‐volt electric socket with ground fault interrupter. After
the device has been connected, the LED on the battery charger stand lights up.
Because of the characteristics of the device is important to follow certain
precautions:
The device should not be used in potentially explosive atmospheres.
Remove packaging, and check the status of the unit.
If any signs of damage to vehicles, alert the manufacturer.
Packaging must be preserved throughout the warranty period.
The manufacturer does not accept returns without original packaging.
L 182 W 95 H 22 (mm)
L 170 W 180 H 145 (mm)
170 gr.
240 gr.
6V DC
3.7 V al litio
Led ad alta potenza
420 ÷ 490 (nm)
1600 mW/cm2 (+/‐ 10%)
9
ENGLISH