Control Function - Toyotomi EPA-100MF Manual De Instrucciones

Control function

Check the household voltage to ensure it matches the appliance's rated specifi cation.
Be sure to plug into a 220-240V, 50Hz outlet.
Introduce of the control panel:
1. Main switch
2. Thermostat knob
3. Indicator light
Operation:
1. Heater is equipped with three power setting. When switch turn to "
When switch turn to " " position, the power is half setting.
When switch turn to " " position, the power is full setting;
2. Turn the thermostat knob clockwise until you reach the maximum position on the graduated scale. When the room
temperature reaches a comfortable temperature, slowly turn the knob anti-clockwise until the heater turns off (you
will hear a click). The heater will now cycle on and off maintain the set comfort level. Take note of this position setting
for future use.
Installation the panel heater
Recommended Installation The convector shall be installed so that produced heat will mix
maximum volume of air. The convector should be attached in accordance with applicable
requirements. The switch and other mechanisms should be away from a person who takes bath
or shower. The device should not be exposed to water splashes. If the device is covered there is
a risk of overheating. It is strictly forbidden to cover or plug inlets and outlets (air grids) as it can
cause an accident or damage the device. DO NOT place the convector behind curtains, doors,
under wall opening or ventilation hole. Keep minimum distance required for installation on fl oor,
surface, near furniture, etc. (Figure 1).
Wall Mounting:
DO NOT fi t the castors to the base of the heater. Make sure
the heater is unplugged from the mains power and the wall
is suitable for mounting the panel heater and there are the
correct clearances. Make sure the panel heater is within 1
meter of a power socket.
Detach the mounting bracket from the rear of the heater by compressing the
2 bracket clips, pulling the clips out of the heater rear & removing the bracket
hooks from the heater.
3
2 1
" position, the heater is power off.
Figure 1
-3-
ENGLISH
Position the bracket on the wall in the desired position & drill holes for two mounting screws. Once the holes are drilled,
use two screws (appropriate for the type of wall) to fi x the bracket fi rmly in place. Check for strength.
Carefully place the heater (slightly tilted forward) onto the hooks at the bottom of the bracket & rotate back so the clips
fi x back into their original holes. Check that they are fi xed correctly. If possible, have a second person help to check for
alignment as the heater is attached. The heater is now ready to connect to the mains power.
Floor Mounting:
The device can be mounted on special legs enabling to move it in the room.
Support foots are attached as follows:
Turn the convector upside down;
Take one of support foots with rollers;
Place the plate of the support foot to the attaching point on the convector so that the dome-shaped part of the plate will
be tightly attached to the convector close to its rear panel the screw holes should match;
Tighten the support foots with the screws in parts kitting.
-4-
ENGLISH