Wall Mounting; Let's Start; Supplied Accessories; Remote Control - ECD XMS 1111 U Manual De Instrucciones

Wall mounting

• Make sure that the place where you
want to attach the device is free from
any cables or pipes inside the wall. We
recommend that the wall mounting
is done by professionals. Use the
supplied installation material and template for wall mounting.
• Mark places on the wall for drilling
holes for the plastic anchors. Make
sure before you drill that the holes are
marked horizontally.
• Drill ¼ inch holes according to the
marks.
• Insert the supplied plastic anchors in
the drilled holes so that they are level
with the wall.
GB
• Insert spacers on the screws and screw
them into the plastic anchors.
• Align the holes on the rear panel with
the installed screws and hang the
device, see picture.

LET'S START

Supplied accessories

Unpack the device carefully and make sure that you received with all included accessories with the device:
• Operating manual
• AC adapter
• Remote controller
• Instruction sheet for wall mounting with a template
• Wall mount kit (2 screws, 2 spacers, 2 plastic anchors)
Power
The equipment requires for operation external DC power 19V DC 2100 mA (AC adapter included). Remote
controller requires 3V lithium battery CR2025 (included). Do not try to power the device from other sources.
This could damage the device and void the warranty.
1. Connect DC connector of power adapter to DC IN connector on the rear side of the device.
2. Insert the plug of the power adapter in an electrical outlet.

Remote control

The remote control is powered by lithium battery CR2025 (included). If you want to activate
the remote control, remove the insulation strip located in the battery compartment. When
the function or range of the remote control becomes impaired, replace the original battery
with a new 3V lithium battery.
1. Pull out the holder with battery from the remote control.
2. Replace the CR2025 battery with a new one. Keep proper polarity of the battery. The
remote control will not work with an incorrectly inserted battery.
• ATTENTION: There is a danger of explosion when battery is incorrectly replaced.
Replace only with a battery of the same type.
3. Insert the holder with the battery in the remote control.
60
60
XMS 1111 U_manual_cz_sk_pl_hu_de_gb_hr_si_sr_fr_it_es_et_lt_lv.indb 60 17.07.2016 16:00:44