Section 2-Assembly; Unpacking The Patient Lift; Assembling The Patient Lift; Assembling The Mast Assembly To The Base - Invacare RPS350-1E Manual Del Usuario

SECTION 2—ASSEMBLY

Unpacking the Patient Lift

Unpack the components from the shipping carton.

Assembling the Patient Lift

WARNING
Use only Invacare parts in the assembly of this
patient lift. The base legs, the mast, boom, pump
assembly and swivel bar are manufactured to
specifications that assure correct alignment of all
parts for safe functional operation.

Assembling the Mast Assembly to the Base

NOTE: The mast assembly may be removed from the base for storage
or transporting. The mast assembly MUST be properly secured to the
base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1. Put the base on the floor.
NOTE: Make sure all four casters make contact with the floor.
2. Lock both rear casters. Refer to Detail "A".
3. Remove the hex bolt, washers and nut that are located in
the U‐shape cut‐out of the base.
4. Lift the mast to an upright position.
5. Lower the mast onto the mounting bracket.
6. Attach the mast to the base with the hex bolt, washers and
nut. Tighten securely.

Preparing Lift for Use

Check and tighten all hardware BEFORE use.

Install the Shifter Handle

NOTE: For this procedure, refer to FIGURE 2.2.
1. Remove the shifter handle from the packaging carton.
2. Thread the shifter handle onto the male adapter on the
base.
Part No. 1078985
Step Here
DETAIL "A"
to Lock
Locking
Lever
UNLOCKED
Washer
Nut
FIGURE 2.1 Assembling the Mast Assembly to the Base
Shifter Handle
Male Adapter
in Base
FIGURE 2.2 Install the Shifter Handle
9
SECTION 2—ASSEMBLY
Step Here
to Unlock
LOCKED
Hex Bolt
Washer
Mounting Bracket
Stand Assist Patient Lift