Maintaining The Guide Bar - Oregon CS1500-091 Manual Original De Instrucciones

• Feed the chain into the groove of the bar and
slide the bar away from the motor to remove
slack from the chain (Fig 37)
FIG. 37
• Install the side cover, making sure the chain
catcher and side cover tab are seated in their
proper locations (Fig 38), then lightly tighten
the side cover release knob
FIG. 38
• Tension the chain as described in "Tensioning
the Saw Chain" in the "Preparing for Use"
section of the manual
IMPORTANT: The saw chain must be
properly tensioned before using. See
"Tensioning the Saw Chain" in the
"Preparing for Use" section of the
manual.
Chainsaw Model CS1500-091
Maintenance and Cleaning

Maintaining the Guide Bar

CAUTION: The guide bar can be hot
after cutting. Wear gloves to avoid burns.
To even bar wear and maximize bar life, flip the
bar occasionally
Wear gloves
• Unplug the chainsaw
• Loosen the side cover release knob slightly,
but do not remove the side cover
• Loosen the chain tensioning ring (turn it
counterclockwise) as far as it will go
• Loosen the side cover release knob and
remove the side cover
• Remove the bar and chain and inspect for
damage and wear
• Remove the screw from the back side of the
chain tensioning gear and remove the chain
tensioning gear from the guide bar (Fig 39)
FIG. 39
• Flip the bar (Fig 40)
FIG. 40
27