EGO POWER+ CS1400 Manual Del Usuario página 43

Side Plate Angle (Fig. 34)
◾ ◾
CORRECT 55°- The optimal angle
can be produced automatically if the
correct diameter file is used in the
file holder.
◾ ◾
HOOK- "Grabs" and dulls quickly.
Increases potential of KICKBACK.
Results from using a file with a
diameter that is too small, or a file
held too low.
◾ ◾
BACKWARD SLOPE- Needs too much feed pressure, causes excessive wear to bar
and chain. Results from using a file with a diameter too large, or a file held too high.
Depth Gauge Clearance
1. The depth gauge should be
maintained at a clearance of
0.025 in. (0.6 mm), as shown in
Fig. 35 . Use a depth gauge tool
(available separately) for checking
the depth gauge clearances.
2. Every time the chain is filed, check
the depth gauge clearance.
Use a flat file and a depth gauge jointer
(both available separately) to lower all
gauges uniformly (Fig. 36). Depth gauge
jointers are available in 0.020 in. to
0.035 in. (0.5 mm to 0.9 mm). Use a
0.025 in. (0.6 mm) depth gauge jointer.
Depth gauges must be adjusted with the
flat file in the same direction the adjoining
cutter was filed with the round file. Use
care not to contact the cutter face with the flat file when adjusting depth gauges.
34
CORRECT
35
36
56V LITHIUM-ION CORDLESS CHAIN SAW
Side Plate Angle
Hook
55°
INCORRECT
Depth Gauge Clearance
Depth Gauge Jointer
Backward Slope
INCORRECT
0.025" (0.6 mm)
Flat File
43