Idiomas disponibles
Idiomas disponibles
NVE 4500 B/ NVE 4600
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing
food in the refrigerator compartment.
Ø Electrical connection
• Warning: Importer use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Products service center.
• This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is
equipped with a three-prong which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
• The cord should be secured behind the refrigerator and not left exposed or dangling to prevent accidental
injury.
• Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out
from the receptacle.
• Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Ø Reversing the Door Swing of Your Appliance.
This refrigerator has the capability of the door opening from either the left or right side. The unit is delivered
to you with the door opening from the left side. Should you desire to reverse the opening direction, please
follow the steps below:
-
Disconnect the appliance.
-
Place the appliance with its back resting on the floor and the door facing upward to the ceiling.
-
Remove the plastic covers (trims on the top of the door), as well as the plug you that will find on the left
upper edge of the door. Remove this plug carefully (for example, using a very fine screwdriver) so as not
to damage it.
-
Remove the screws that you will find on the upper and lower part of the door holding the hinges.
-
Once you have removed the screws, take out the hinges and place them on the left side of the door.
-
Attach the hinges with the screws that you removed earlier, making sure the parts are properly aligned.
-
Place plastic covers (changing their sides) and place the plug on the right upper edge of the door.
12
