Premier ED-5053GL Manual De Instrucciones página 10

11. Unplug the product from the electrical outlet prior to putting on or removing parts.
12. Never operate this product if it has a damaged Power Cord or plug, is not working properly, has been
dropped or damaged, or if the Base has been exposed to water or other liquids. Do not attempt to
examine or repair this product yourself. Only qualified service personnel should perform servicing.
Take the product to an appliance repair shop of your choice for inspection and repair.
! !
CAUTION-- To reduce the risk of personal injury or product damage:
13. When using electrical appliances, basic safety precautions should always be followed including the
following.
14. Close supervision is necessary when any appliance is used by or near children.
15. To reduce the risk of injury,never place cutterd-assenbly blades on base without jar properly
attached.
16. Always operate blender with cover in place.
17. The use of attachments,including canning jars,not recommended by the manufacturer may cause a
risk of injury to persons.
18. When blending hot liquids,remove center piece of two-piece cover.
19. Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons
or damage to the blender(another trade name may be used). A scraper may be used but must be
used only when the blender is not running(does not apply to an acceptable scraper integral with the
appliance).
20. Blades are sharp.Handle carefully.
21. Any other servicing should be performed by anthorized service representative.
22. This appliance has a polarized plug(one blade is wider than the other).To reduce the risk of electric
shock,this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet,reverse the plug.If it still does not fit,contact a qualified electrician.Do not modify the plug in any
way.
23. This product is intended for indoor,non-commercial,non-industrial,household use only.Do not use
outdoors.
SPECIAL INSTRUCTIONS:
 To avoid a circuit overload when using this product, do not operate high. Wattage product on the
same electrical circuit.
 Avoid the use of an extension cord because the extension cord may overheat increasing the risk of
fire.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS DIAGRAM:
1. Cap
2. Lid
3. Jar
4. Gasket
5. Blade Assembly
6. Blade Base
7. Motor Housing
8. Power cord
NOTE: Parts 3-6 are initially assembled in the packaging.
P-3