Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operation
The following cleaning procedure will help
you to organize your cleaning task, and
ensure that you achieve the most beneficial
results in the shortest amount of time.
Remember to use the spraying/cleaning
techniques previously listed.
1. Surface preparation
Before starting a pressure wash cleaning
job, it is important to prepare the surface
that is to be cleaned. This is done by
cleaning the area of furniture, and making
sure that all windows and doors are closed
tight. In addition, you should make sure that
all plants and trees adjacent to the cleaning
area are protected by a drop cloth. This will
ensure that your plants won't be sprayed by
the detergents.
2. Initial High Pressure Rinse
The next step is to spray the cleaning
surface with water to clear off any dirt or
grime that may have collected on the
surface. This will allow your detergent to
attack the deep down dirt that has worked
its way into the cleaning surface. Before
triggering the gun, adjust the nozzle to a
wide fan pattern and slowly adjust to the
desired spray pattern. This will help you
avoid applying too much concentrated
spray to the surface which could cause
damage.
3. Detergent Application
USE THE INSTRUCTIONS
APPROPRIATE FOR MODEL
PURCHASED
NOTE:
Use only detergents formulated for
pressure washes.
NOTE:
Test detergent in an inconspicuous
area before use.
Figure 5 Detergent application
Units with Detergent Applicator
Included
Follow manufacturer's label directions for
mixing correct concentrations of detergent
to water ratio through the pressure washer
is approximately 5.4% (1 to 19).
Tabla de contenido
