Connections - Omnitronic EX-840 Manual Del Usuario

4. CONNECTIONS

• Install the device on a plane surface.
• Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be
switched off.
• In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• You can connect up to 3 amplifiers to the EX-840. The output signal of the Master 1-signal can be adjusted via the Master 1-fader and the balance-control. The output signal of the Master 2-signal can be adjusted via
the Master 2-control. The output-signal of the Booth-signal can be adjusted via the Booth-control.
• The Master 1-output can either be connected via the RCA-sockets or the balanced XLR mounting-plugs.
Due to the lower interference problems, we recommend to use the XLR mounting-plugs.
Occupation balanced XLR mounting-plug:
• The Master 2-output can be connected via the RCA-sockets. Make sure that the sockets are set properly (L
& R).
• Via the BOOTH sockets, you can either connect monitor active speakers for the DJ-booth or an additional
amplifier for creating a second zone.
• For recording, connect your tape recorder or cassette deck to the REC OUT-sockets. The REC OUT level
will not be influenced by the master fader. You can set the output level with the channel faders, the tone
controls and the GAIN control.
• The EX-840 features one separately controllable microphone channel (MIC 1). This microphone can be
connected via the XLR/1/4" jack-mounting socket on the frontpanel accepting ¼" jack plugs and XLR-plugs.
With the Talkover-button, you can attenuate the level of all other signal-sources without affecting the
microphone volume.
Occupation balanced XLR-socket:
Occupation balanced stereo-1/4" jack-plug:
Balanced XLR mounting-plug:
1: Ground
2: In Phase (+ )
3: Out of Phase (-)
2 1
3
Balanced XLR-socket:
1: Ground
2 1
2: In Phase (+ )
3
3: Out of Phase (-)
22/47 10007050_V_1_1.DOC