Cleaning The Containers; Shaving Container (Optional); Liquid Container; Cleaning Or Replacement Of The Vapour Filters - Nilfisk WSS 100 Manual De Instrucciones

WSS100 - WST100

Cleaning the containers

Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.

Shaving container (optional)

■ Clean the container after each emptying (see "Emptying
the shaving container" paragraph).
■ Check that the holes are free of dirt; clean them if
necessary.

Liquid container

1 Float and relative support
2 Shaving container (optional)
3 Container closing band
4 Liquid exhaust valve
■ Empty the liquid container (see "Emptying the containers"
paragraph).
■ Open the liquid container closing band (3).
■ Lift the motor head.
■ Remove the float and its support (1) or the shaving
container (2) (optional).
■ Wash the container with water to remove deposits.
■ Open the exhaust valve (4) to empty the container.
■ Close the exhaust valve (4).
■ Place the float and its support or the shaving container (if
applicable) back into position.
N.B. Make sure the float support is correctly
positioned (fig. 9).
■ Lock the motor head by using the liquid container closing
band (3).
GB
09/2014
WARNING!
Figure 9
Cleaning or replacement of the vapour
filters
1 Filters
2 Baffle plate
3 Filter box
■ Remove the safety screw (4) and open the motor head
clamp (5).
■ Lift the motor head.
■ Remove the filter box (3) by unscrewing the fixing
screws.
■ Remove the filters (1) and the baffle plate (2), then clean
the filters with water or replace them if necessary.
■ Reinstall the filters (1) and the baffle plate (2) making
sure they are correctly positioned.
■ Install the filter box and secure it by screwing the fixing
screws.
■ Reinstall the motor head and close the container with the
appropriate closing band, then put the safety screw in
place (4).

Tightness inspection

1 Vacuum hose
2
Liquid level indicator tube
■ Hoses check
Make sure that the suction connecting hose (1) and the
level hose (2) are in a good condition and correctly fixed.
If the hose is damaged, broken or badly connected to the
unions, it must be replaced.
1 Gasket
2 Liquid container
3 Motor head
■ Motor head tightness check
Replace the seal (1) between the container (2) and the
motor head (3) if it is torn, cut, etc.
8
Figure 10
Figure 11
Figure 12