Metabo HPT CJ 36DA Manual De Instrucciones página 15

NOTE
○ Confi rm the protrusions of blade inserted to the blade
holder surely.
○ Confi rm the blade located between the groove of
roller. (Fig. 11)
Blade
Roller
5. Adjusting the blade operating speed
The jig saw is equipped with the electric control
circuit which enables stepless speed control. To
adjust the speed, turn the dial shown in Fig. 12.
When the dial is set to "1", the jig saw operates at
the minimum speed (800 /min). When the dial set
to "5", the jig saw operates at the maximum speed
(3,500 /min). Adjust the speed according to the
material to be cut and working effi ciency.
Blade operating speed
Mode
Standard Mode
AUTO Mode
With AUTO Mode, the vibration frequency may not reach 3,500 /min depending on variables such as the type of
work.
CAUTION
At low speed (dial setting: 1 or 2) do not cut a
wood with a thickness of more than 5/16" (8 mm)
or metal with a thickness of more than 1/32"
(1 mm).
6. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which moves
the blade back and forth, as well as up and down. Set
the change knob shown in Fig. 13 to "0" to eliminate
the orbital operation (the blade moves only up and
down). The orbital operation can be selected in 4
steps from "0" to "III".
Blade
Roller
Fig. 11
Dial
1 – 5
A
No-load speed
3,500 /min
1,400 /min
800 /min
Dial
<About Operation mode>
The tool is equipped with two modes: "Standard
Mode" and "AUTO Mode".
(1) Standard Mode
You can change the blade operating speed between
800 to 3,500 /min by adjusting the dial from "1" to "5".
(2) AUTO Mode
AUTO Mode automatically selects a speed between
1,400 and 3,500 /min to suit the operating load and
maintains that speed until the switch is turned off .
This has the eff ect of lowering vibration and noise
prior to and during operation.
Adjust the dial for the mode and speed that best suits your
task conditions and materials.
Blade operating speed
800 – 3,500 /min
No load: 1,400 /min
With load: 3,500 /min
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft material,
such as lumber, plastic, etc., increase the orbital
operation to increase work effi ciency. To cut the
material accurately, decrease the orbital operation.
English
Fig.12
Change knob
Fig. 13
15