Electrical Connection; Before You Begin; Tools And Parts Needed; Parts Included - Bosch HCP34E51UC Instrucciones De Instalación

Electrical connection

, WARNING
RISK OF ELECTRIC SHOCK
Parts inside the appliance can have sharp edges. The
connection cable can be damaged. Do not bend or
pinch connection cables during installation.
Before connecting the appliance, check the household
installation. Ensure sufficient fuse protection of the
household installation. The voltage and frequency of the
appliance must match the electrical installation (see rating
plate).
The appliance complies with protection class 1 and must
only be operated in conjunction with a protective
conductor terminal.
An all-pole isolating switch with at least a 3 mm contact
gap must be fitted in the installation. This must remain
accessible after installation.
Only a qualified electrician who takes the appropriate
regulations into account may lay or replace the connecting
cable.
Follow all valid standards and laws.

Before You Begin

Tools and Parts Needed

Measuring tape

Pencil

Phillips screwdriver (Posidrive) #2

Drill with the following bits: 5/16" (7.9 mm) and 3/8"

(9.5 mm)
Spirit-level

Aluminum tape (DO NOT use insulating tape)

 Exhaust channel (configuration depends on the
installation situation)
Additional sheet metal screws (if necessary for

installation of the exhaust air duct)
Saw

Ensure that the electrical connection meets the
requirements of the latest version of all applicable
standards and laws in the appropriate country, especially
the following standards: National Electrical Code, ANSI/
NFPA 70*, or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No.0-M91**.
Have a qualified electrical technician check the grounding
of the appliance.
Do not ground with a gas line.
No fuse protection in the neutral or grounding circuit. Keep
the installation instructions. Only connect the appliance
with a copper conductor. If possible, connect the
appliance to a metal cable guide directly to the fuse box.
Ensure that the wire diameter meets the requirements of
the latest version of all applicable standards and laws in
the appropriate country, especially the following
standards: National Electrical Code, ANSI/NFPA 70*, or
CSA Standards C22.1-94, Canadian Electrical Code,
Part 1 and C22.2 No.0-M91**.
Put a protecting hose that is listed in the U.L. or C.S.A. on
both ends of the connecting cable, that is, on the
appliance and on the fuse box.
For copies of the standards listed, contact:
* National Fire Protection Association Batterymarch Park
Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575

Parts included

Extractor hood with fan, back-pressure flap

Lamp, already installed

Metal grease filter

Flue duct

 Drill template
1x angle bracket for the flue duct

Instruction manual and installation instructions

 6x screws, 5x45 mm
8x screws, 4.2x8 mm

6x hollow wall plugs, 8x40 mm

Torx adapter, 10 & 20

9