Positioning - DRIJA MILAN 60 Manual De Instrucciones

positioning

700mm
400mm
FO 0813
60G40ME005-SFN/SFT(-R01/R02)
60G40ME090-SFN/SFT(-R01/R02)
60G40ME091-SFN/SFT(-R01/R02)
60G40ME092-SFN/SFT(-R01/R02)
60G40ME007-GFN/GFT(-R01/R02)
60G40ME093-GFN/GFT(-R01/R02)
60G40ME094-GFN/GFT(-R01/R02)
60G40ME095-GFN/GFT(-R01/R02)
60G40ME006-FFN/FFT(-R01)
60G40ME006-WFN/WFT(-R01)
o The edges of the hob must be a minimum distance of
rear wall.
o 700 mm between the highest point of the hob surface (including the burners)
and the underside of any horizontal surface directly above it.
o 400 mm between the hob surfaces, providing that the underside of the
horizontal surface is in line with the outer edge of the hob. If the underside of
the horizontal surface is lower than 400 mm, then it must be at least 50 mm
away from the outer edges of the hob.
o 50 mm clearance around the appliance and between the hob surface and any
combustible materials.
o You must have a gap of at least 25 mm and at most 74 mm between the
underneath of the appliance and any surface that is below it.
- An oven must have forced ventilation to install a hob above it.
- Check the dimensions of the oven in the installation manual.
- The cut out size must obey the indication.
60 0mm
400mm
700mm
400mm
FO 0813
60G40ME401-SFN/GFN(-R01/R02)
60G40ME401-SFT/GFT(-R01/R02)
60G40ME403-SFN/GFN(-R01/R02)
60G40ME403-SFT/GFT(-R01/R02)
60G40ME411-SFN/GFN/SFT(-R01)
60G40ME413-SFN/SFT(-R01/R02)
60G40ME084-GFN/GFT(-R01/R02)
60G40ME085-GFN/GFT(-R01/R02)
60G40ME087-SFN/SFT(-R01/R02)
60G40ME086-GFN(-R01/R02)
600
45 mm
GB-14
600mm
400mm
60 mm from a side or