Before Operation; Adding/Checking Engine Oil; Fuel Cap; Fuel Cap Air Vent - Powermate PM0152000 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Adding / Checking Engine Oil
Place generator on a level surface.
Remove screws and then remove the outer casing cover.
Remove the crankcase dipstick.
Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of
4-Cycle engine oil to empty reservoir until or oil reaches the outer edge of the oil fill hole
(crankcase dipstick hole).
Be sure to replace dipstick and securely tighten before attempting to start the engine.
To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick
without re-threading.
Recommended Oil: See Oil Recommendations on page 15.
Oil Capacity: 0.35L (11.8 oz)

Fuel Cap

Turn counterclockwise to remove the fuel cap.

Fuel Cap Air Vent

The fuel cap is equipped with an air vent to stop fuel from flowing to the carburetor. The Air
Vent must be in the "ON" position to allow fuel to flow so that the engine can run. Turn the
Air Vent to the "OFF" position to stop fuel flow.

Fuel

Fill the tank with clean, fresh unleaded automotive gasoline. Regular grade gasoline may be
used provided a high octane rating is obtained (at least 85 pump octane). We recommend
always using a fuel stabilizer. A fuel stabilizer will minimize the formulation of fuel gum
deposits during storage. The fuel stabilizer can be added to the gasoline in the fuel tank, or
into the gasoline in a storage container.

Adding Fuel

Set generator on a clean and level surface in an area that is well ventilated.
Do not smoke while adding fuel.
Remove fuel cap.
Insert a funnel into the fuel tank and carefully pour gasoline into the tank until fuel level reaches about 1 ½ inches below the
top of the neck. Be careful not to overfill the tank to provide space for fuel expansion.
Replace fuel cap and secure tightly.
English

BEFORE OPERATION

BEFORE OPERATION
Generator has been shipped without engine oil. Add
oil before operating this generator. Always check oil
level before each operation.
11
Customer Hotline 1-800-445-1805
Tabla de contenido
loading

Tabla de contenido