Operation - Lacor 69079 Instrucciones De Uso Y Mantenimiento

1.- Remove the wrapping before using the electrical appliance. Do not discard the wrapping
until you have checked that the blender is working correctly.
2.- Make sure that the motor unit is placed on a flat, dry surface. Avoid contact with
areas of excessive heat. Check that the connection cable and the power point are in perfect
condition.
3.- Have fruit or vegetables prepared (for example: cut apple, carrot or other fruit and
vegetables cut into pieces), then add water. Do not exceed the maximum line on the
blender. If you wish to crush ice, add several ice cubes and water and then cover.
4.- Position the main shaft in the central housing of the motor unit. Insert the plastic cutting
blade (only to be used for cutting vegetables and fruit).
Properly position the glass jug on the motor unit. The motor will not run if it is not properly
placed, since the safety switch in the main body is not activated.
Insert the fruit or vegetables that you want to chop, or you can add them later by using the
tube in the jug lid.
Make sure the lid is properly closed, as the handle of the jug has a safety device, which
must be properly set for the engine to work.
5.- Turn the control knob clockwise, the motor will start and the speed can be increased by
turning the knob to the right. Use the position P (PRESS), located to the left of the control
knob, to chop to the desired size at full speed.
Once complete, turn the knob anti-clockwise to stop the motor.
6.- Remove the jug with its lid by turning it 90° anti-clockwise to separate it from the motor unit.
Open the cover by turning it 30° anti-clockwise and you now have a jug of processed fruit or
vegetables.
CAUTION: The blade is still inside so you should exercise extreme caution to avoid cuts
and injury to fingers and hands.
ACCESSORIES INCLUDED:

OPERATION

BLENDER JUG
To use the blender jug, place it on the motor unit, turn
90° clockwise to fix its position and add the ingredients to
be blended.
Never use the jar without the lid, as the centrifugal force
will force the liquid out. This is also the basic safety
measure to avoid risks to people.
When the blending is finished, remove the jug by turning
90° anti-clockwise
28