Preparation For Use; Legal Information - Ottobock 9X50 Instrucciones De Uso

Accessories
The following components are not included in the scope of delivery and must
be ordered separately:
• 13E129=* electrode cable

6 Preparation for use

6.1 Required Tools
• 633F11 silicone grease
6.2 Connecting the electrode cable
1) Shorten the electrode cable as needed.
2) Push the electrode cable with the grey side up into the plug connection
all the way to the stop (see fig. 1).
3) Apply sufficient silicone grease to the inside of the control element hous­
ing and the contact pins (see fig. 2).
4) Connect the plug connection between the housing and electrode cable
plug.
5) Push the plug on the electrode cable as deep as possible into the
product using a screwdriver (see fig. 3).
6) Remove any silicone grease that seeps out.
Electrode cable replacement
1) Pull off the electrode cable at right angles to the product (see fig. 4).
2) Cut off at least 5 mm of the electrode cable and push it back into the
plug connection.
7 Use
The 9X50 linear control element and the 9X51 4-stage control element are
attached between the shoulder harness and definitive socket (see fig. 5).

8 Legal information

8.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of
the product.
Ottobock | 15