Bresser Explore Scientific RDP3007 Manual De Instrucciones página 10

ALARM
SETTING/ADJUSTING DUAL ALARM TIME
You can set two alarm times (AL1 and AL2).
1. Press the [ ] button to display Alarm 1.
2. Press and hold [
mode for the currently selected alarm (Alarm 1).
3. The setting parameter will flash.
4. Press [ ] or [ ] button to set the desired data.
5. Press [ ] button to confirm setting and enter to
next parameter.
6. Sequence of setting: Hour  Minute  Exit
7. Alarm will turn on automatically when alarm setting
is finished.
8. If there is no action in 20 seconds, the setting will be
saved and will exit the setting mode.
TURN ON/OFF ALARM
1. In alarm display mode, press the [
turn on/off the current alarm. when in calendar dis-
play mode, the sequence is: AL1 on  AL2 on 
AL1+AL2 on  AL1+AL2 off.
10
] to enter the alarm setting
] button to
2. The alarm lasts 2 minutes and becomes faster and
faster over time.
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [
delay the alarm by 8 minutes.
3. If you do not press any button to stop the alarm, it
will automatically turn off after 2 minutes.
4. To stop the alarm, press [
except SNOOZE.
5. The alarm will start again at the next alarm time,
unless you switch off the alarm function by press-
ing the [ ] button.
PROJECTION
The projector displays the time or temperature on your
ceiling or wall and it can rotate 180°. It is easier to view
in a darkened room. For the optimal projection results,
place the unit within 1.5 - 2 m (5-6.5 ft) from the ceiling
or wall.
] button to
] or any other button