Starting A Warm Engine; Stopping The Engine - Echo CSG-7410ES Manual De Instrucciones

Engine operation
1. Throttle trigger
Engine warm-up

Starting a warm engine

1. Starter grip
1. Choke knob

Stopping the engine

1. Momentary stop switch
1. Choke knob
2. Throttle trigger lockout
2. Throttle trigger
8. Pull throttle trigger and the throttle latch will be released.
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
1. Fill the fuel tank with fuel mixture. It is not permitted to fill fuel
above the shoulder level of fuel tank.
2. Press the decompression device.
3. Securely hold the engine cut-off saw. Pull starter grip briskly,
but only 1/2 to 2/3 its full length. Pulling rope to the end may
damage the starter.
∗ If the engine is hard to start, pull the choke knob, latching the
throttle and then return the choke to its normal position. (This
opens the throttle slightly.) If it still fails to start, revert to the
WHEN ENGINE IS COLD starting procedure.
1. Release the throttle trigger and allow the engine to idle (i.e.
low speed).
2. Push the momentary stop switch until the engine is stopped.
∗ If engine does not stop, pull choke control knob all the way out
to stop engine. Return the unit to your authorized dealer to
check and repair momentary stop switch before starting the
engine again.
With trigger latched, wheel will rotate as soon as engine
starts. Keep wheel in the clear.
Wheel will rotate for some time after the trigger is re-
leased. Keep wheel in the clear until all movement
stops.
24
WARNING