Clamping The Wheel; Universal Clamping Means; Motorcycle-Clamping Means; Centering And Clamping Means For Quick Span Machines - Nussbaum BM Touch Serie Manual De Instrucciones

7.1.1

Clamping the wheel

Choose the correct cone that fits into centre hole of the
wheel and place onto the main shaft of the clamping
means.
Place the wheel onto the main shaft and steady it on
the left side with the left hand as close to the adapter
flange as possible. Fit the clamp with the right hand by
pushing it up to the rim and tighten by turning clockwise.
7.2

Universal clamping means

(Sonderzubehör) not for BM 55 Touch
Some French automotive manufacturers prefer to use
rims without centre holes. We can offer as special clam-
ping means ordered from accessories (Item No. 1 987
009 W01N).
The rim is clamped using a centering ring with special
wheel bolts to enable a secure fit.
7.2.1 Clamping the wheel
Fit and secure the clamping means to the machine fol-
lowing the respective instructions. Select and fit the cor-
rect centering ring.
Choose the correct amount and size of mounting bolts
according to the amount of mounting holes on the rim
i.e. 3-, 4- or 5 hole rims, and screw into the adapter flan-
ge and tighten. Carry out a Zero run in order to compen-
sate for any residual unbalance in the clamping means.
Place the wheel onto the adaptor and tighten each
bolt to secure the wheel in position.
54
7.3 Motorcycle–Clamping means
(special accessory) not for BM 55 Touch
We also offer a special clamping means from our ac-
cessory program for all types of motorcycle wheels in-
cluding those with one arm assembly (such as BMW or
Ducati ) which fit all machines except BM 55 Touch.
!
Before mounting the clamping means make sure
that the cones, main shaft and clamping means
are all clean and in good condition.
Place the adaptor onto the main shaft conical end and
secure using the centre bolt using the supplied Allen
Key.
For further information, please see detailed instructions
supplied with the tool.
7.3.1 Clamping the wheel
Fit and secure the motorbike clamping means to the
machine following the respective instructions.
The standard motorbike clamp is not suitable for bikes
with a one arm assembly (BMW, Ducati etc. In this case
a special adapter is also needed.
Choose the correct cone and distance ring according
to the size and width of the centre hole. Place the wheel
onto the main shaft and secure. Detail instructions are
enclosed with the clamping means.
059
7.4 Centering and clamping means for Quick
span machines
(only BM 55 Touch)
Quick span machines do not use a hand clamp to se-
cure the rim to the machine; instead it has a pneumatic
powered quick clamping device operated by a foot
pedal.
The complete pneumatic clamping unit is connected
to the main shaft assembly and uses the same cones to
centre the rims as with the standard machines. Other
special centring means can also be found in our pro-
gram of accessories.
12.08.2013 AD W9002 N