John Bean B 800 Manual Del Operador página 150

1
1
150
7-4
7-5
3
7-6
2
3
7-7
Setting Parameters
7.4.2 Counters
Every measuring run actually completed is stored.
Maximum count is 999,999 runs. Once this number is
reached, the counter is reset to zero. The information
is primarily useful for statistical purposes, e. g. to obtain
evidence of load intervals of parts when defective,
or of monthly (yearly) use of the machine, etc. The
measuring runs performed while the machine is on
are transferred into the permanent memory and added
when it is switched off. The counter cannot be reset
or changed.
3
— Select the "Counters" category (1, Fig.7-4) in
the SETTINGS screen (Figure 7-5) .The data
immediately available in the Values fi eld are the
a
following:
List of Counters
b
a Total spins = Total number of measuring
c
b Spins with = Number of measuring runs where
o.k.
d
c Optimisation
runs
e
d Service
f
e Since last
calibration
f Clamps
7.5 Input of promotional text
— Select the "General Settings" category in the
SETTINGS screen, then select one of the 5
parameters in the central panel "Promotional Text"
(3, Fig. 7-6).
After the selection a keyboard is displayed with the
text entry fi eld.
To switch to upper case and additional characters
press (1, Fig. 7-7).
To go back by one position in the text, press (2, Fig. 7-7).
To close and enter the current text string, press
"ENTER" (3, Fig. 7-7).
The promotional text, saved automatically, will appear
in the Main Screen INTRO SCREEN exactly as
entered by the user.
(Figure 7-5)
runs
balance quality was considered OK
= Number of optimisations or
minimisations
= Number of measuring runs in
service mode
= Number of measuring runs
since the last calibration
= Total number of wheels clamped
........