HIKOKI P 20SB Instrucciones De Manejo página 8

English
PLANER SAFETY WARNINGS
1. Wait for the cutter to stop before settling the tool
down.
An exposed rotating cutter may engage the surface
leading to possible loss of control and serious injury.
2. Hold the power tool by insulated gripping surface
only, because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator
an electric shock.
3. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by your hand or against the body leaves
it unstable and may lead to loss of control.
SPECIFICATIONS
Voltage (by areas)*
Power Input
Cutting Width
Max. Cutting Depth
Weight (without cord)
No-Load Speed
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
1. Box Wrench (for securing cutter blade) ............. 1
2. Set Gauge (for adjusting cutter height) .............. 1
3. Guide (with set screw) ........................................... 1
4. Blade Sharpening Ass'y .......................................... 1
Standard accessories are subject to change without notice.
APPLICATIONS
Planing various wooden planks and panels.
Planing
Max. 6mm
Rabbeting
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
7
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
Max. 12mm
Max. 12mm
Beveling
4. Do not use the Planer with the blades facing upward
(as stationary type planer).
5. Use dust collection adapter if need to reduce dust
related hazards.
(1) Unscrew the left side screw on bearing cover
(Item no. 23 show in assembly drawing) on
housing.
(2) Mount dust collection adapter on housing with
screws.
Dust collection adapter (Code no. 313928)
(3) Connect the dust extraction and collection
facilities with the tube of dust collection adapter
firmly.
(4) Wear dust mask additionally, if available.
570W*
82mm
1mm
2.5kg
15000 min -1
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Prepare a stable wooden workbench suitable for
planing operation. As a poorly balanced workbench
creates a hazard, ensure it is securely positioned
on firm, level ground.
PLANING PROCEDURES
1. Adjusting the cutter depth:
(1) Turn the knob in the direction indicated by the
arrow in Fig. 1 (clockwise), until the triangular mark
is aligned with the desired cutting depth on the
scale. The scale unit is graduated in millimeters.
(2) The cutting depth can be adjusted within a range
of 0-1mm.
2. Surface cutting:
Rough cutting should be accomplished at large
cutting depths and at a suitable speed so that
shavings are smoothly ejected from the machine.
To ensure a smoothly finished surface, finish cutting
should be accomplished at small cutting depths and
at low feeding speed.