Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
2 Useful Information / 3 Operating
GB
2.2
Heat treatment and red light
Pedicure
The MEDISANA PR-F90 foot spa heats up the water until the choosen tem-
using
perature of the water is reached. The water will be kept on this temperature
the PR-F90
level - it will not increase while using the device. Choose a temperature by
foot spa
pressing the button
The red light may support the blood circulation. The radiation penetrates the
soles of your feet and causes a smooth, warm feeling.

3 Operating

3.1
Before filling the device with water, make sure, that no connection to the
Filling with
mains is present - therefore, the mains plug must not be plugged in! Only
water
plug in the mains plug when the device is filled with water and placed firmly
on an even ground and cannot tip over. The MEDISANA PR-F90 foot spa
can be filled with up to 7.3 litres of water. The maximum filling height is
marked in the foot spray bath. You can use cold or warm water with or with
out bath additives, just as desired.
CAUTION
Make sure, that your MEDISANA foot spa is used on a damp-
resistant surface, where it cannot tip over.
Never use any foaming bath additives or bath salts.
3.2
ON/OFF
Function
After connected with the mains, press the button
setting
ance. Spray function and red light are activated.
Press the on/off button again
Temperature
The MEDISANA PR-F90 foot spa includes an innovative heating function.
This technical improvement makes it possible to keep the water at a con-
stant temperature during application or to warm it.
To activate the heat function, press the temperature selection button once
. The Display
6
tial value = 42°C). The water will be heated up, until the displayed value is
reached. Each press on the temperature selection button
setting value by 1°C (setting range: 30°C - 45°C). If no button is pressed for
some seconds, the display will show the actual water temperature. The heat
function LED
13
. The red light may be switched on or off separately.
6
8
flashes and shows the desired temperature setting (ini-
9
lights up when the heat function is activated.
7
8
and the device will switch off.
to switch on the appli-
increases the
6
Tabla de contenido
loading

Este manual también es adecuado para:

88870

Tabla de contenido