Tabla de contenido
Idiomas disponibles
Idiomas disponibles
indicates, tool is being overloaded.
4. Electrical surges and high frequency interference may cause
RPM fluctuations up to 30% which will disappear as soon as
power source conditions stabilize. Due to electromagnetic
interference at a lower speed range the drive motor may
shut-off prematurly. In this case, activate on/off switch and
restart.
Attention: Even if the cut-out is not activated, danger of over-
loading always exists, thus don't force the tool in order not to
increase unnecessarily excessive current draw, which over-
heads the motor.
Speed selection
Select required speed with variable speed selector 6 for cor-
rect surface feet./M.O.S.
Speed selector
Position
rpm
1
1' 000
2
1' 200
3
1' 400
4
1' 600
5
1' 800
6
2' 000
Attention: Do not change pre-selected speed while tool is run-
ning and has working tools mounted.
• Do not treat any material containing asbestos.
Caractéristiques technique
Puissance absorbée
Puissance rendement
Vitesse à vide
Outil ø max.
Niveau de pression acoustique
selon EN 50144
Vibration selon EN 50144
Filetage de broche selon modèle
(voir liste des pièces de rechange)
Poids sans câble environ
Classe de protection
Tension (voir liste des pièces de rechange)
Eléments de machine
1
Broche
2
Tête d'oangle
4
Disconnect Tools
When changing accessories, such as wheels and discs
• Lock spindle 1 with wrench 7.
• Suitable Tools 9 to 14 mount or dismount using wrench 8.
• Check concentricity, use only vibration free tools and always
Maintenance
• Store tool in a clean, dry place.
• Disconnect tool when not in use and before servicing.
• The ventilator openings for cool air must be kept free and
• Replace grease in grinder head every other time, when
• Damaged plugs and cords must be replaced immediately.
• Repairs must only be done by a qualified/licensed electri-
• Warranty claims can only be considered, if tool is returned
Accessories
All accessories can be found in the SUHNER® Abrasive Power
Tool catalog.
Subject to change!
3
500 Watt
4
5
300 Watt
6
7
-1
1'000-2'000 min
8
125 mm
Outils utilisables
75 dB(A)
9
10
3,1 m/s
2
12
M 14 ou
5/8" - 11
14
1,5 kg
Pour d'autres outils veuillez consulter le catalogue SUHNER.
II
diverse
Instructions de sécurité
• Ne jamais dépasser la vitesse de rotation de l'outil
• Veiller à ce que les pièces soient fixés conformément aux
observe M.O.S. (Max. operating speed).
clean, use air gun to blow out dirt.
carbon brushes are replaced. Use the SUHNER authorized
service center nearest you .
cian, otherwise it could be hazardous to the operator.
complete.
Filetage de poignée
Poignée
Interrupteur
Sélecteur de vitesse
Clé sw 17 mm
Clé sw 22 mm
Buffle en éponge
Disque élastique avec disque en papier autocollant 11
Disque de pollisage en feutre avec buffle en peau de
mouton 13
Abrasiv brosse nylon.
instructions.
FR
Tabla de contenido
