Bosch GSR18V-535FC Instrucciones De Funcionamiento Y Seguridad página 18

2610055572 GSR18V-535FC 01-2020.qxp_GSR18V-60FC 1/28/20 8:40 AM Page 18
▶ Autolock™
The tool is equipped with an automatic
locking system. This feature will lock the
bit holder in one position when the trigger
switch is released. This will allow tighten or
loosen a nut or screw by rotating the tool
by hand with the switch off. This is
convenient when higher turning torque is
needed.
▶ KickBack Control (Rapid Shut-off)
To ensure better control of the tool
during operation, this tool is designed
to shut-off while in use if a sudden or
unexpected bind up situation occurs. Bind up
occurs when the bit gets jammed during
operation, which forces the bit to stop
spinning abruptly. If this occurs, the tool will
shut down and the KickBack Control will be
indicated by flashing LED lights on the tool.
The sensitivity level of this feature is
adjustable. Using Bosch Toolbox app on a
mobile device, operator may select one of
three settings between "Earlier" and "Later"
markers on the app. The settings only control
the KickBack Control activation delay, and do
not change the capacity of this feature.
When the switch trigger is pressed, operator
is notified about the KickBack Control
settings, by the work light and function red
light identified in Fig. 1 on page 10.
The setting indications are as follows:
Continuous white light (W) = Later
W
(delayed Kick Back activation).
18
▶ Built-in Work Light
The tool is also equipped with a light that
turns on automatically when the switch is
activated, for better visibility when
drilling/driving (Fig. 1).
Slow alternating red (R) and white (W)
R W R W
light = Mid-Level (less delayed
activation).
Fast alternating red (R) / white (W)
R R R R W W W W
light = Earlier (minimum delay to
activation).
The label next to the work light displays the
Kick Back setting indicator light pattern.
This feature can only be activated when the
tool is running at maximum speed.
NOTE: The default KickBack Control setting
for the tool is "Later". KickBack Control
setting for the tool without GCY42 module
installed is always set to default.
SAVE THESE INSTRUCTIONS
RED LIGHT WHITE LIGHT