Operation; Switching On And Off; Cleaning Shoes And Boots; Cleaning Leather / Leather Care - Westfalia Ellipse Manual De Instrucciones

Operation

Switching on and off

The machine is started via a foot sensor button or hand sensor but-
ton, and switches off automatically via a time relay after approx. 40
seconds, if the sensor button is not activated again, or for models
with pushbutton on the rod, the power circuit is interrupted at the
moment that the pushbutton on the rod is released.

Cleaning shoes and boots

When using, strictly ensure that you are standing in front of the
machine in a manner that is stable and so that you cannot slip.
The closed shoes or boots to be cleaned must only be cleaned when
they are on the foot of the user of the machine. Use with untied
shoelaces or other loose parts on the shoe is prohibited, and in
addition to damaging the shoes, can also cause severe damage to
the machine.
Attention - danger of injury!

Cleaning leather / leather care

First, briefly brush off the edges of the shoe and the leather surface
on the middle, black, pre-cleaning brush. Attention - excessive pres-
sure on the brush can damage the leather. For models with polish
dispenser, carefully press the tip of the shoe against the polish
valve from below, until one or two drops of polish are applied on the
leather surface via the valve. Distribute this polish over the entire
shoe with the appropriate soft polishing brush (light brush for light
shoes, dark brush for dark shoes) and polish the leather smooth
through light pressure against the brushes. The leather becomes
smooth and ductile through the special polish. For models without
polish dispenser, polish (as described above), however without
polish. By slightly turning the shoe it is also possible to clean the
sides of the shoe.

Cleaning and care of the machine

Cleaning the housing

Always unplug the power plug and thus disconnect the power sup-
ply prior to cleaning. We recommend using a dry or slightly damp
microfiber cloth to clean the housing. Do not use cleaning agents or
household cleaners.

Rubber honeycomb mat

The dirt that is brushed off collects in the rubber honeycomb mat
under the brushes. The mat can be taken out and is easy to empty,
i.e. clean.
Topping up the polish dispenser
Through the view window on the polish dispenser holder,
you can see when the polish is used up. To top up the polish see
the chapter Commissioning > filling the polish dispenser

Replacing the polish bottle for model Polifix 4

Through visual inspection, check the fill level of the polish in the
bottle and replace the bottle with a new bottle, if the polish is
completely used up. To replace the bottle, see the chapter Commis-
sioning > Use of the polish bottle for model Polifix 4
Order your replacement polish from us in good time.
A call or fax is all it takes!

Regular maintenance

Dirty brushes and the rubber honeycomb mat should be regularly
cleaned or replaced as needed. Damaged or worn out brushes must
be replaced immediately.
Only for modules with polish valve:
At regular intervals, check whether sufficient polish (check
the view window in the polish holder or check the polish
bottle for the Polifix 4 model) is present in the container and
that the polish valve of your shoe shine machine functions
properly.

Service and repairs

All electrical repairs must only be carried out by customer service
personnel or qualified electricians. Unplug the power plug for all
repair tasks on the machine!
When ordering space parts, provide the following information:
Serial number
Year of manufacture
The rating plate with this information is on the rear of the machine.
EN
17