Transportation, Storage And Disposal; To Put Supports Below The Product - Husqvarna R112C Manual De Usuario

Problem
The cutting result is unsatisfacto-
ry
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.

To put supports below the product

WARNING: Always put supports on the 2
sides of the product to make it stable.
1. Park the product on a hard and level ground.
1466 - 002 - 28.09.2020
Cause
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
18 .
The tire pressure is different on the right and left sides. See
page 23 .
The product is operated at a too high speed. See
The engine speed is too low. See
The drive belt slips.

Transportation, storage and disposal

To examine the blades on page 24 .
To get a good result on page 17 .
Technical data on page 29 .
2. Remove the cutting deck. Refer to
cutting deck on page 11 .
3. Lift the product with a jack assembly.
4. Put the front supports below the front wheel axles.
5. Put the rear supports below the rear frame.
To clean the product on page
Tire pressure on
Technical data on page 29 .
To remove the
27