Homeguard BS8000 Manual De Usuario página 8

To enter telephone numbers:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 2 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press the [ * ] button: One high tone is given for confirmation.
4. Enter the first telephone number you selected (max. 16 digits). If a dialling pause is
required (e.g. with a certain type of PABX between 0 and the number you want to dialled
in order to obtain an outside line) press another [ * ] for a one second pause. One high tone
is given for confirmation of each number entered.
5. Press #: One high tone is given for confirmation.
6. Press 1 to place the telephone number you just entered in memory location 1. One short
low tone is given and the green indicator stops flashing.
Repeat this procedure with the two other selected telephone numbers by pressing 2 and 3
for placing these in memory positions 2 and 3 respectively.
Note: All three numbers should be entered. You may enter the same number more than
once.
Call Identification:
If you select telephone numbers of people who's number has been entered by more than
one HomeGuard, you can transmit an extra audible signal with the pre-recorded message
in order to identify the HomeGuard calling. The factory default is one beep at the end of
the message.
To change the number of beeps (1, 2 or 3):
1.Enter your PIN
2.Press 4 on the keyboard
3.Press 1, 2 or 3 for the required number of identification beeps.
Tone / Pulse dialling
The built-in telephone dialler of the HomeGuard is suitable to dial on DTMF Tone as well
as Pulse telephone systems. Default setting for the dialler is DTMF Tone.
To set the unit to Pulse dialling proceed as follows:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 8 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press the [ # ] button: One high tone is given for confirmation.
To return to DTMF dialling:
1. Enter PIN
2. Press 8
3. Press [ * ]
7. REGISTERING REMOTE CONTROLS AND WIRELESS SENSORS
HomeGuard can be remotely controlled by up to 4 radio remotes. For security reasons,
each remote selects a unique code (1 out of 65.536) after the battery has been installed.
Also it is possible to register additional sensors* to the HomeGuard Base console. Any
combination of up to 4 remotes and sensors can be made, e.g. 2 sensors + 2 remotes, or 3
sensors + 1 remote.
HomeGuard
8
revision 01-05-2005