Homeguard BS8000 Manual De Usuario página 6

8. External alarm contact:
This input allows you to connect any external alarm device with a non-powered NO
(Normally Open) or NC (Normally Closed) contact. E.g. smoke alarms, magnetic
door/window contacts, flood and temperature detectors, etc.
You may connect multiple devices in series to the HomeGuard. This allows you to turn
your HomeGuard into a complete security system with built-in telephone dialler.
To connect any external security device, use the supplied cable with mini-plug or install an
equivalent jack plug on these devices.
3. WIRELESS KEY FOB REMOTE CONTROL KR21 (OPTION)
1. ARM:
Will put the HomeGuard into the armed position.
The alarm is instant or delayed. Delayed arming
allows you to leave the room within 30 seconds
or enter the room and switch off the alarm within
15 seconds after entering. The factory default is
instant arming (no delay). To change this setting
please refer to Delayed Arm (7).
2. DISARM:
Switches off and resets the HomeGuard.
3. PANIC:
If pressed simultaneously will cause an alarm
instantly.
4. LIGHTS ON / LIGHTS OFF:
These buttons are not used with default
HomeGuard.
5. LED:
Indicator flashes if remote transmits a command.
If indicator does not flash or lights up weakly,
replace the batteries.
The battery holder is located inside the remote.
The back of the remote can be easily opened
using your fingernails or a small screwdriver.
Only use 3V lithium batteries model CR2016. Push the ARM key for more than 3 seconds
and release the button; the indicator blinks. If batteries are replaced, you've to re-register
with the base station (refer to installation).
HomeGuard revision 01-05-2005
6