Homeguard BS8000 Manual De Usuario página 11

1. The person called pressing 0 on the telephone dialler just after the beep(s) in the
message.
2. Disarming the sys tem on the keyboard by entering your PIN followed by [ * ]
3. Pressing DISARM on the remote control (option).
Alarm message:
During an alarm the telephone dialler will dial the first number. It will start transmitting the
pre-recorder message as soon as the last digit has been dialled. The message lasts 9
seconds and will be repeated twice. The pre-recorded message is followed by a beep.
After this beep the system will wait for call confirmation which can be given by pressing 0
on a DTMF (touch tone) telephone. In case the confirmation is not received, the
HomeGuard will start dialling the second number and follow the same procedure. If the
second person does not give confirmation, the third number will be dialled.
NOTE:
Instruct the person who's num ber has been entered to give the confirmation 0 just after the
beep(s). Since telephone answering machines or voice mail facilities will not generate the
confirmation, these will be ignored. It is recommended to do a test with the people involved
in order to let everyone get aquatinted with the system.
12. TROUBLESHOOTING
1. The base station does not react at all, the green indicator is not on:
Check the power supply and/or the replace the back-up battery.
2. The telephone dialler does not dial out:
Check that the telephone plug is connected properly
Check that the telephone outlet is responding to a normal analog telephone.
3. False alarms:
Reposition the HomeGuard, away from heating elements, direct sunlight, etc.
Check that no pets can trigger the alarm.
4. Limit ed range of the remote or sensor (option):
Check the condition of the battery and replace the battery if required.
Check if no other devices interfere on the same frequency e.g. wireless headphones etc.
5. PIR or siren do not respond:
Check that PIR or SIREN has been activated.
6. The sensor HomeGuard does not react to the remote:
Follow the registration procedure in order to lock in the remote.
Check that the indicator on the remote comes on. If not, replace the battery
7. Any other malfunction:
Disconnect the HomeGuards from mains and back-up battery. This will reset the
HomeGuard. Re-install the HomeGuard according to the instruction manual.
Do not open the power supply or HomeGuard. No serviceable parts inside!
HomeGuard revision 01-05-2005
11