Blade Guiding; Setting The Cutting Height; Saw Table Tilt - LEMAN LOSRU250 Manual De Instrucciones

2.2 Blade Guiding

The saw blades guide
of this band saw ensure
an exact guiding of the
blade for clean cuts.
When using narrow
blades ensure that the
lower blade guide
positively supports the
blade from both sides
and the rear. Set the
bearings of the upper blade guide to within approx. 0.5 mm of the blade, and the large thrust bearing against the back of the
blade, just clear of it. Do not set the bearing too close, as the friction generates heat, which may have an adverse effect on the
bearings and the saw blade as well.

2.3 Setting the Cutting Height

The upper blade guide should always be set as
close as practical against the work. To adjust,
loosen the wing nut at the side of the upper
wheel housing, and set the blade guide to the
required height. Tighten wing nut after setting.

2.4 Saw Table Tilt

For bevel cuts the saw table tilts steplessly through
45°. To tilt, loosen the wing nut on the table
trunnions, set table to the required angle and tighten
the wing nut again. Exchange the table insert
against the one with the wide slot, so the blade can
travel freely.
It is recommended to verify the correct angle setting
by making trial cuts in scrap wood.
- 4 -
EN