Elite CID12 Manual De Usuario página 25

NOTE
The battery is not fully charged. Before using the tool, the battery pack requires 8 to 10 hours to be fully char-
ged. The subsequent recharge will require 3 to 5 hours for the battery to be fully charged.
Always replace the battery with a new (or freshly charged) one when the performance of the tool begins to
decrease. Intense heat is extremely damaging to batteries; the more heat is generated, the faster the battery
loses energy. A battery that gets too hot can have a short life.
Never discharge the battery excessively by repeatedly using the tool after the performance of the tool has
decreased. Do not attempt to discharge the battery by continuously pressing the trigger of the tool. When the
battery performance begins to decrease, stop the tool and recharge the battery for optimal performance.
Replace the battery pack at room temperature between 5500 °° FF - 110044 °° FF ((1100 °° aa 4400 °° CC)).
Store the tool and battery pack in locations where temperatures do not exceed 120 ° F (49 ° C). This is impor-
tant to prevent serious damage to the battery cells.
The battery pack must be recharged when the drill begins to run slowly.
When not in use, keep the battery pack away from other metal objects such as paper clips, coins, keys, nails,
screws, or other metallic objects that can make a connection between one terminal and another. If the battery
terminals are shorted, sparks, burns or fires can occur.
REMOVAL AND INSTALLATION OF THE BATTERY PACK
REMOVING THE BATTERY PACKAGE:
1. Press the front release button
of the Cordless Drill to release the
battery pack.
2. Pull the battery pack to remove it from the Wireless Router.
INSTALLATION OF THE BATTERY PACK
1. Align the protrusion of the battery pack with the notch in the
corresponding compartment of the Wireless Talador.
2. Press the battery pack until it snaps into place.
Make sure that the latches are firm. Do not use the Drill
Wireless if the battery pack is not firmly installed.
www.ELITETOOLS.co
Keep Working
7