Timer Function - S&P EMIDRY-D Manual De Instalación. Instrucciones De Uso

8.5 Maximum temperature settings.
Although the thermostat supports a temperature range between +5ºC and +35ºC,
this range can be reduced to limit the maximum temperature setting to +15ºC,
thus restricting the temperature range to between +5ºC and +15ºC. Access to this
function is protected by a non-intuitive programming procedure. This function
helps avoid energy waste. To reduce the maximum temperature, proceed as
follows:
1. Press and hold the
setting (35ºC by default) flashes on the display .
2. Press and
Each press increases or reduces the temperature setting by 1ºC. Once 5 seconds
have elapsed and the keys have not been pressed again, the value is accepted
and the display returns to normal mode.

8.6 Timer function

With this function the appliance can be programmed to stop or start at any point
in a time range of 99 hours. Settings increase in increments of 15 minutes up to
9 hours and 45 minutes, and in increments of one hour from 10 to 99 hours. This
function can be used to keep the appliance on for a pre-determined duration, e.g.
before going to bed, or to switch it on at a pre-determined time, e.g. before get-
ting up. It can also be used for programming the appliance to switch on after a
prolonged stoppage, e.g. before returning home after a weekend away. To acti-
vate this function:
1 Press and hold
flashes.
2 Press or
For 15-minute increments (up to 9 hours 45 minutes), each horizontal line repre-
sents an extra 15 minutes to be added to the digit on the left. Thus 1 horizontal
line represents 15 minutes, 2 lines represent 30 minutes, 3 lines represent 45
minutes. From 10 hours upwards, each press/line represents on hour.
Flashing
Once 5 seconds have elapsed with no further buttons pressed, the programmed
setting is accepted, the display once again shows the ambient temperature, the
key for 2 seconds. The current maximum temperature
to move the maximum temperature to the desired setting.
for 2 seconds. The display shows "0 " and the upper left blob
to select the desired setting.
Example 6h 45m
Where it
corresponds
18