Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation / Operation
To Power
Male Pipe to Male Hose Adapter
(Suction)
Male Pipe to Male Hose Adapter
(Discharge)
Female Hose Connection
To reduce friction losses to a minimum, inlet (suction)
line should be short and have as few elbows as possible.
Figure 4 – Wall mounted to pressurized service line.
Size the inlet according to the chart below:
Threaded Inlet
Ave . GPM
Size
10
3/4/" NPT
For parts or assistance, call Flotec Customer Service at
Service Line
Gate Valve or Hose Bibb
Male Pipe to Male Hose Adapter
High Pressure Hose with two
Female Connections
Gun Nozzle
Weeping Type ONLY
High Pressure Hose
1209 0894
Recommended
Recommended
Discharge Line
Inlet Line Size
Size
1"
1"
An inlet strainer will prevent suspended debris from
clogging pump.
The internal running surfaces of the pump and seals
require water lubrication for good, consistent operation.
Allowing pump to run dry or with no flow will severely
damage pump and seals.
Install a pressure gauge in pump inlet line. Keep at least
two pounds per square inch pressure (2 PSI) in inlet
line whenever pump is operating. If this is not possible,
consult customer service representative.
Lubrication
It is not necessary to lubricate pump or motor. The motor
is equipped with sealed ball bearings, lubricated for
the life of the bearing. The mechanical shaft seal in the
pump is self-lubricating and requires no adjust ment.
Disassemble pump to replace seal, see Maintenance.
Operation
NOTICE Observe the following precautions when
operating the pump:
1. Keep the motor dry! Do not direct stream from pump
discharge onto the motor!
2.
Risk of explosion . Do not ground to a
gas supply line. Do not run the pump with discharge
shutoff, as hose may burst or pump may be damaged
due to high temperatures.
3. Do not use a standard trigger gun with this
pump. Use only trigger guns with an automatic
weeping feature.
4. Do not run pump dry; to do so may damage the seal.
5. To avoid internal damage to pump, do not operate
with water temperature above 175 degrees F.
800-365-6832
5
Tabla de contenido
